tag:blogger.com,1999:blog-910685024071367839.post8531243072194356591..comments2024-03-22T05:52:25.544-04:00Comments on BuildIts in Progress: Ball TurnerBen Katzhttp://www.blogger.com/profile/15816221191617788028noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-910685024071367839.post-65474026026273215132018-07-17T10:12:58.240-04:002018-07-17T10:12:58.240-04:00Nice.Nice.onjoFilmshttps://www.blogger.com/profile/09259359254651271707noreply@blogger.comtag:blogger.com,1999:blog-910685024071367839.post-6533102123405267092015-10-25T00:25:48.081-04:002015-10-25T00:25:48.081-04:00I drilled the whole by flipping the whole piece ar...I drilled the whole by flipping the whole piece around in the lathe before parting off the ball, and drilling through all the extra stock. To tap it, I held it in a vice with a v block, with some rubber sheet between the ball and the vice/block.Ben Katzhttps://www.blogger.com/profile/15816221191617788028noreply@blogger.comtag:blogger.com,1999:blog-910685024071367839.post-14934973427500287342015-10-24T20:27:07.824-04:002015-10-24T20:27:07.824-04:00how did you hold the ball to drill and tap it?? Co...how did you hold the ball to drill and tap it?? Cool build!amyqianhttps://www.blogger.com/profile/10578748619643832443noreply@blogger.com